Dell Precision M6500 - Removing the Access Panel; Replacing the Access Panel

Back to Contents Page
Access Panel
DellPrecision™WorkstationM6500ServiceManual
Removing the Access Panel
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the screws that secure the access panel to the computer.
4. Slide the access panel towards the battery compartment.
5. Pull the access panel away from the computer.
Replacing the Access Panel
To replace the access panel, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.