Dell Precision M6500 - Wireless Local Area Network (WLAN) Card; Removing the Wlan Card; Replacing the WLAN Card

Back to Contents Page
Wireless Local Area Network (WLAN) Card
DellPrecision™WorkstationM6500ServiceManual
Removing the WLAN card
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the access panel.
4. Disconnect the antenna cables from the WLAN card.
5. Remove the screw that secures the WLAN card to the system board. The card pops up at a 45-degree angle.
6. Slide the WLAN card out of the connector on the system board.
Replacing the WLAN Card
To replace the WLAN card, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.