Dell Precision M6500 - Page 43

Back to Contents Page
Video-Card Assembly
DellPrecision™WorkstationM6500ServiceManual
Removing the Video-Card Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the access panel.
4. Remove the secondary hard drive.
5. Remove the hinge cover.
6. Remove the keyboard.
7. Remove the display assembly.
8. Remove the palm rest.
9. Remove the heat sink.
10. Disconnect the video-fan cable from the system board.
11. Loosen the captive screws that secure the video-card assembly to the computer.
12. Remove the video-card assembly from the computer.
Replacing the Video-Card Assembly
To replace the video-card assembly, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.