Dell Precision M6500 - Removing the Secondary Hard Drive; Replacing the Secondary Hard Drive

Back to Contents Page
Secondary Hard Drive
DellPrecision™WorkstationM6500ServiceManual
Removing the Secondary Hard Drive
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the Battery.
3. Remove the Access Panel.
4. Remove the screws that secure the secondary hard drive to the computer.
5. Pull the black tab to lift the hard drive up and away from the computer.
6. Remove the screws on either sides of the hard drive to release the hard-drive bracket from the hard drive.
7. Remove the hard-drive bracket from the hard drive.
8. Remove the hard-drive interposer from the hard drive.
Replacing the Secondary Hard Drive
To replace the secondary hard drive, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.