Dell Precision M6500 - Removing the Camera; Replacing the Camera

Back to Contents Page
Camera
DellPrecision™WorkstationM6500ServiceManual
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the access panel.
4. Remove the hinge cover.
5. Remove the keyboard.
6. Remove the display assembly.
7. Remove the display bezel.
8. Remove the display panel.
9. Disconnect the camera cable from the camera.
10. Remove the screws that secure the camera to the display assembly.
11. Remove the camera from the display assembly.
Replacing the Camera
To replace the camera, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.