Dell Precision M6500 - Removing the Coin-Cell Battery; Replacing the Coin-Cell Battery

Back to Contents Page
Coin-Cell Battery
DellPrecision™WorkstationM6500ServiceManual
Removing the Coin-Cell Battery
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the battery.
3. Remove the access panel.
4. Slide the coin-cell battery out of the mylar sleeve.
5. Disconnect the coin-cell battery cable from the system board and remove it from the computer.
Replacing the Coin-Cell battery
To replace the coin-cell battery, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe®Flash®Player from Adobe.com in order to view the illustrations below.