Dell QMD8262-k - Page 114

3–Adapter Management Applications
Windows Management Applications
99 CU0354602-00 L
Table 3-6 lists miscellaneous Windows diagnostics commands.
Table 3-7 lists the Windows CLI diagnostic test commands. Note that while
running these tests, network traffic is interrupted.
qaucli -pr fc -h Print Fibre Channel and FCoE protocol usage and then exit
qaucli -pr iscsi -h Print iSCSI protocol usage and then exit
qaucli -npar -h Print NPAR (Switch Independent Partitioning) commands
usage and then exit
Table 3-6. Miscellaneous Commands
Command Description
qaucli -v Print version number and then exit
qaucli -h Print usage and then exit
Table 3-7. Diagnostic Test Commands
Command
a
Description
-i
--interface
Specifies the interface type (NX_NIC, NX_NIC1, and so on)
-a
--all
Perform all test, regardless of default
-D
--default
Perform only default test
-R
--CRegs
Test all control registers (default)
-I
--IRQS
Test interrupt mechanism (default)
-L
---IntLB
Internal loopback test (default)
-H
--Hw
Hardware test (default)
-S
--LinkST
Link status test (default)
-nR
--noCRegs
No control registers test (combine –D or –a)
-nl
--noIRQS
No interrupt test (combine –D or –a)
Table 3-5. Getting Help (Continued)
Command Description