3–Adapter Management Applications
Windows Management Applications
98 CU0354602-00 L
To run user diagnostics in the CLI:
Use QConvergeConsole CLI (qaucli), a unified command line utility, to manage all
QLogic adapter models, including running user diagnostics.
The overall option (-pr <protocol>) allows you to start the utility with a specific
protocol type, either NIC, iSCSI, or Fibre Channel. If you do not specify a protocol,
all protocols are enabled by default. Table 3-3 and Table 3-4 list the
QConvergeConsole commands for selecting a protocol.
Diagnostic help commands, and command options available for each specific
protocol, are available by specifying -h to the protocol, as shown in Table 3-5.
Table 3-3. Selecting a Protocol in Menu Mode
Command Description
qaucli Start QConvergeConsole CLI in interactive mode
qaucli -pr nic [options] Issue NIC command line options
qaucli -pr iscsi [options]
Issue iSCSI command line options
qaucli -pr fc [options]
Issue Fibre Channel and FCoE command line options
qaucli -npar [options] Issue NIC partitioning (NPAR) (Switch Independent
Partitioning) command line options
Table 3-4. Selecting a Protocol in Legacy Mode
Command Description
qaucli -nic [options] Use NIC legacy command line
netscli [options] Use NIC legacy command line
qaucli -iscsi [options] Use iSCSI legacy command line
iscli [options] Use iSCSI legacy command line
qaucli -fc [options] Use Fibre Channel legacy command line
scli [options] Use Fibre Channel legacy command line
Table 3-5. Getting Help
Command Description
-h Print usage of a specific adapter type and then exit
qaucli -pr nic -h Print NIC protocol usage and then exit
To Next Page
Loading...