Using Your Projector 35
Using the Control Panel
1 Power Turns the projector on or off. For more
information, see "Turning Your Projector On" on
page 30 and "Turning Your Projector Off" on
page 30.
2 Up / Keystone
adjustment
Press to navigate through the On-Screen Display
(OSD) Menu items.
Press to adjust image distortion caused by tilting
the projector (+37/-40 degrees).
3 LAMP warning light If the LAMP amber indicator is on or blinking,
one of the following problems could be occurring:
• Lamp is reaching its end of usable life
• Lamp module is not properly installed
• Lamp driver failure
• Color wheel failure
For more information, see "Troubleshooting Your
Projector" on page 126 and "Guiding Signals" on
page 132.
1 3
5
2
10
4
7
6
9 8
To Next Page
Loading...
