Dell S5830DN - Using Hibernate mode

Use To
On Reduce printer noise.
Notes:
• Print jobs process at a reduced speed.
• Printer engine motors do not start until a
document is ready to print. There is a short delay
before the first page is printed.
• The alarm control and cartridge alarm sounds are
turned o.
• The printer ignores the Advance Start command.
O Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
4 Click Submit.
Adjusting Sleep mode
1 From the home screen, navigate to:
> Settings > General Settings > Timeouts > Sleep Mode
2 In the Sleep Mode
field,
select the number of minutes the printer is idle before it enters Sleep mode.
3 Apply the changes.
Using Hibernate mode
Hibernate is an ultra‑low‑power saving mode.
Notes:
• Three days is the default amount of time before the printer enters Hibernate mode.
• Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long
press of the Sleep button wakes the printer from Hibernate mode.
• If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1 From the home screen, navigate to:
> Settings > General Settings
2 To uc h Press Sleep Button or Press and Hold Sleep Button.
3 Tou ch Hibernate > .
Saving money and the environment 136