Replace unsupported imaging unit [32.xy]
Remove the imaging unit, and then install a supported one to clear the message and continue printing. For
more information, see the instruction sheet that came with the supply or see the “Replacing supplies” section
of the User’s Guide.
Note: If you do not have a replacement imaging unit, then see the “Ordering supplies” section of the
User’s Guide or visit our Web site.
Restore held jobs?
Do either of the following:
• Select Restore on the printer control panel to restore all held jobs stored in the printer hard disk.
• Select Do not restore if you do not want any print jobs to be restored.
Serial port [x] disabled [56]
Try one or more of the following:
• From the printer control panel, select Continue to clear the message.
The printer discards any data received through the specified serial port.
• Select Reset active bin to reset the active bin for a linked set of bins.
• Make sure the Serial
Buer
menu is set to Enabled.
Some held jobs were not restored
From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
• From the printer control panel, touch Continue to continue printing.
• Turn o the printer, and then turn it back on.
• Update the network firmware in the printer or print server. For more information, contact technical
support or your Dell printer dealer.
Standard USB port disabled [56]
Try one or more of the following:
• From the printer control panel, touch Continue to clear the message.
• Enable the USB port. From the printer control panel, navigate to:
Network/Ports > USB
Buer
> Auto
Note: The printer discards any data received through the USB port.
Troubleshooting 185
To Next Page
Loading...
Need help?
General
