Dell S5830DN - Incorrect characters print

Incorrect characters print
Action Yes No
Step 1
Make sure that the printer is not in Hex Trace mode.
Note: If Ready Hex appears on the display, then turn o the
printer, and then turn it back on to deactivate Hex Trace mode.
Is the printer in Hex Trace mode?
Deactivate Hex
Trace mode.
Go to step 2.
Step 2
a From the control panel, select Standard Network or
Network [x], and then set PCL SmartSwitch or PS SmartSwitch
to On.
b Resend the print job.
Do incorrect characters print?
Contact
technical
support.
The problem is
solved.
Job prints from the wrong tray or on the wrong paper
Action Yes No
Step 1
a Check if you are printing on a supported paper.
b Print the document.
Is the document printed from the correct tray or on the correct
paper?
The problem is
solved.
Go to step 2.
Step 2
a Depending on your operating system, specify the paper size
from the Printing Preferences or Print dialog.
Notes:
• Make sure that the settings match the paper loaded in
the tray.
• You can also change the settings on the printer control
panel.
b Print the document.
Is the document printed from the correct tray or on the correct
paper?
The problem is
solved.
Go to step 3.
Step 3
a Check if the trays are not linked.
b Print the document.
Is the document printed from the correct tray or on the correct
paper?
The problem is
solved.
Contact
technical
support.
Troubleshooting 197