• Install a flash memory card with larger capacity.
Note: Downloaded fonts and macros not previously stored in the flash memory are deleted.
Paper changes needed
Try one or more of the following:
• From the printer control panel, select Prompt for each page to continue printing.
• Select Use current supplies to continue printing using the paper loaded in the tray.
• Cancel the current print job.
Parallel port [x] disabled [56]
Do either of the following:
• From the printer control panel, select Continue to clear the message and continue printing.
The printer discards any data received through the parallel port.
• Select Reset active bin to reset the bin for a linked set of bins.
Reattach bin [x]
Try one or more of the following:
• Turn o the printer, and then turn it back on.
• Reattach the indicated bin.
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bin.
4 Reattach the bin.
5 Connect the power cord to a properly grounded electrical outlet.
6 Turn the printer back on.
• Remove the indicated bin:
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet.
3 Remove the indicated bin.
4 Contact technical support or your Dell printer dealer.
• From the printer control panel, touch Continue to clear the message and print without using the
specified
bin.
Troubleshooting 181
To Next Page
Loading...
Need help?
General
