Steps
1. Using the pull tab, disconnect the camera cable from the camera module.
2. Using a plastic scribe, pry the camera module from the display assembly.
NOTE: Start prying the camera module in a sequential order 1>2>3 as indicated on the display back cover.
3. Lift the camera module from the display assembly.
Installing the camera module
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
NOTE: This procedure applies for systems shipped with plastic chassis.
About this task
The following images indicate the location of the camera module (in a system shipped with plastic chassis) and provide a visual
representation of the installation procedure.
Steps
1. Adhere the camera module in its slot on the display assembly.
2. Connect the camera cable to the camera module.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the hinge caps.
5. Install the display assembly.
6. Install the wireless card.
7. Install the SSD - M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
8. Install the base cover.
9. Follow the procedure in After working inside your computer.
Removing and installing components
57
To Next Page
Loading...
