Installing the Input/Output board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the installation procedure.
Steps
1. Place the I/O board on the palm-rest and keyboard assembly.
2. Align the screw holes on the I/O board to the screw holes on the palm-rest and keyboard assembly.
3. Close the hinge and replace the two (M2x3.5) screws that secure the display hinge to the palm-rest and keyboard assembly.
4. Connect the fingerprint-reader board cable to the connector on the I/O board and close the latch (if applicable).
5. Connect the I/O board power cable to the connector on the I/O board and close the latch.
Next steps
1. Install the display assembly.
2. Install the fan.
3. Install the SSD - M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
4. Install the base cover.
5. Follow the procedure in After working inside your computer.
62
Removing and installing components
To Next Page
Loading...
