Display cable
Removing the eDP cable (Plastic)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever applicable.
4. Remove the wireless card.
5. Remove the display assembly.
6. Remove the hinge caps.
7. Remove the display bezel.
8. Remove the display hinges.
9. Remove the display panel.
NOTE: This procedure applies for systems shipped with plastic chassis.
About this task
The following image indicates the location of the eDP cable (in a system shipped with plastic chassis) and provides a visual
representation of the removal procedure.
58
Removing and installing components
To Next Page
Loading...
