Next steps
1. Install the display assembly.
2. Install the memory module.
3. Install the heat sink UMA (based on configuration).
4. Install the system fan.
5. Install the WLAN card.
6. Install the M.2 2230 solid-state drive.
7. Install the M.2 2280 solid-state drive.
8. Install the battery.
9. Install the base cover.
10. Follow the procedure in after working inside your computer.
Removing the system board - discrete
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
4. Remove the M.2 2280 solid-state drive.
5. Remove the M.2 2230 solid-state drive.
6. Remove the WLAN card.
7. Remove the system fan.
8. Remove the heat sink.
9. Remove the memory module.
10. Remove the display assembly.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
Disassembly and reassembly
85
To Next Page
Loading...
