● iDRAC User Interface - From the iDRAC Dashboard, click Configurations, and then click BIOS settings.
● Text browser - To enable the text browser, use the Console Redirection option.
Steps
1. To view the System BIOS screen, power on the system and press F2 during the boot process.
2. Click System Setup Main Menu.
If the operating system begins to load before you press F2, wait for the system to finish booting, and then restart the
system and try again.
The following table describes the options in the System Setup Main Menu:
Table 10. System Setup Main Menu
Option Description
System BIOS Configure the BIOS settings.
iDRAC Settings Interface to set up and configure the iDRAC parameters by using Unified Extensible Firmware
Interface (UEFI). You can also enable or disable various iDRAC parameters. For more
information about this utility, see the Integrated Dell Remote Access Controller User’s Guide.
Device Settings Configure the settings for devices such as storage controllers or network cards.
Service Tag Settings Use this option to configure the system Service Tag information.
System information
In the BIOS, access System Information to view several details.
Steps
1. To view the System Information screen, power on the system and press F2.
2. Click System Setup Main Menu > System BIOS > System Information
The following table lists the information available:
Table 11. System Information details
Option Description
System Model Name This option specifies the system model name.
System BIOS Version This option specifies the BIOS version that is installed on the system.
System Management Engine Version This option specifies the current version of the Management Engine
firmware.
System Service Tag This option specifies the system Service Tag.
System Manufacturer This option specifies the name of the system manufacturer.
System Manufacturer Contact
Information
This option specifies the contact information of the system manufacturer.
System CPLD Version This option specifies the current version of the system Complex
Programmable Logic Device (CPLD) firmware.
UEFI Compliance Version This option specifies the UEFI compliance level of the system firmware.
Pre-operating system management applications 23
To Next Page
Loading...
Need help?
General