Graphics Card 39
Replacing the Graphics Card
1
Align the graphics card with the PCI-Express x16 card connector on the
system board.
2
Place the card in the connector and press down firmly. Ensure that the card
is firmly seated in the slot.
3
Connect the power cable to the graphics card, if applicable.
4
Replace the card-retention bracket, ensuring that:
• The guide clamp is aligned with the guide notch.
• The top of all cards and filler brackets are flush with the alignment bar.
• The notch on top of the card or filler bracket fits around the
alignment guide.
1 PCI-Express x16 connector 2 graphics card
3 securing tab 4 power cable
1
4
2
3
book.book Page 39 Wednesday, April 4, 2012 2:00 PM
To Next Page
Loading...
