Power Button Module 91
Replacing the Power Button Module
1
Align and push the power button module tabs into the slots on the top
panel.
2
Connect the power button module cable to the system board connector,
F_PANEL. See "System-Board Components" on page 21.
Postrequisites
1
Replace the top cover. See "Replacing the Top Cover" on page 78.
2
Replace the optical drive. See "Replacing the Optical Drive" on page 69.
3
Replace the front bezel. See "Replacing the Front Bezel" on page 33.
4
Replace the computer cover. See "Replacing the Computer Cover" on
page 25.
5
Follow the steps in "After Working Inside Your Computer" on page 15.
book.book Page 91 Wednesday, April 4, 2012 2:00 PM
To Next Page
Loading...
