Delta C2000 Plus Series User Manual

Chapter 16 PLC Function ApplicationsC2000 Plus
16-147
Step 6: Connect hardware wiring
When performing wiring, note the head and tail terminal resistance; connection methods are
as follows:
Step 7: Initiate control
After a program has been written and downloaded, switch the PLC mode to Run. Merely turn
power to master and slave stations off and then on again.
Refer to CANMasterTest 1 vs. 2 driver.dvp
Terminal
resistor
Terminal
resistor

Delta C2000 Plus Series Specifications

General

Altitude	Up to 1000m without derating
Communication	CANopen
Output Current	2.5A
Protection Features	Overcurrent, Overvoltage, Overtemperature
Operating Temperature	-10°C to 50°C
Storage Temperature	-20°C to 60°C
Humidity	95% RH (non-condensing)