Delta C2000 Plus Series - Page 354

Chapter 10 Digital KeypadC2000 Plus
10-9
20. Over-voltage stall prevention
(Pr.06-01)
21. Over-current stall prevention during
acceleration (Pr.06-03)
22. Derating protection (Pr.06-55)
23. Software brake chopper action level
(Pr.07-00)
24. Emergency stop (EF) & force to stop
selection (Pr.07-20)
25. Encoder type selection (Pr.10-00)
26. Encoder pulses per revolution (Pr.10-01)
27. Encoder input type setting (Pr.10-02)
28. System control (Pr.11-00)
29. Per-unit of system inertia (Pr.11-01)
30. ASR1 low-speed bandwidth (Pr.11-03)
31. ASR2 high-speed bandwidth (Pr.11-04)
32. Zero-speed bandwidth (Pr.11-05)
5. TQCPG Mode
01: Password Decoder
Items
1. Parameter protection password input
(Pr.00-07)
2. Parameter protection password setting
(Pr.00-08)
3. Control mode (Pr.00-10)
4. Speed control mdoe (Pr.00-11)
5. Master frequency command source (AUTO)
/ Source selection of the PID target
(Pr.00-20)
6. Operation command source (AUTO)
(Pr.00-21)
7. Max. operation frequency (Pr.01-00)
8. Motor 1 rated / base frequency (Pr.01-01)
9. Motor 1 rated / base voltage (Pr.01-02)
10. Full-load current for induction motor 1
(Pr.05-01)
11. Rated power for induction motor 1
(Pr.05-02)
12. Rated speed for induction motor 1
(Pr.05-03)
13. Number of poles for induction motor 1
(Pr.05-04)
14. No-load current of induction motor 1
(Pr.05-05)
15. Over-voltage stall prevention
(Pr.06-01)
16. Software brake chopper action level
(Pr.07-00)
17. Encoder type selection (Pr.10-00)
18. Encoder pulses per revolution (Pr.10-01)
19. Encoder input type setting (Pr.10-02)
20. System control (Pr.11-00)
21. Per-unit of system inertia (Pr.11-01)
22. ASR1 low-speed bandwidth (Pr.11-03)
23. ASR2 high-speed bandwidth (Pr.11-04)
24. Zero-speed bandwidth (Pr.11-05)
25. Max. torque command (Pr.11-27)
26. Torque offset source (Pr.11-28)
27. Torque offset setting (Pr.11-29)
28. Torque command source (Pr.11-33)
29. Torque command (Pr.11-34)
30. Speed limit selection (Pr.11-36)