10. Right click on the CPU module image as shown below, select Communication Software then click
EtherCAT to do ECAT master / slave station settings in ECAT Builder software.
11. Click on the Network Scan button, then click Scan on the pop-up window. Then select MS300 /
MH300 (CMM-EC02) in the Equipment Name to export to the network. If the scan result doesn’t
show MS300 / MH300 equipment, verify if the wiring is correct. Refer also to the ESI Import Process
at the end of this chapter to import ESI files of slave station and scan again.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
To Next Page
Loading...
