Delta CP2000 Series User Manual

Chapter 12 Description of Parameter SettingsCP2000
12.1-09-18

Communication Card Gateway Address 4 (for Modbus TCP)
Default: 0
Settings 0–65535

Communication Card Password (Low word) (for Modbus TCP)

Communication Card Password (High word) (for Modbus TCP)
Default: 0
Settings 0–99

Reset Communication Card (for Modbus TCP)
Default: 0
Settings 0: Disable
1: Reset, return to default

Additional Setting for the Communication Card (for Modbus TCP)
Default: 1
Settings bit0: Enable IP Filter
bit1: Enable internet parameters (1bit)
When IP address is set, this bit is enabled.
A
fter updating the
communication card parameters, this bit changes to disabled.
bit2: Enable login password (1bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to disable.
Communication Card Status (for Modbus TCP)
Default: 0
Settings bit0: Enable password
When the communication card is set with a password, this bit is
enabled. When the password is cleared, this bit is disabled.

Delta CP2000 Series Specifications

General

Output Voltage	0 ~ Input Voltage
Communication Interface	RS-485
Storage Temperature	-20°C to 60°C
Input Voltage	200-240V AC, 380-480V AC
Protection Functions	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short Circuit