87
Installation and Operation Manual for Inverter RPI M50A_12s V1 EU EN 2017-03-09
8 Settings
8.4.4 Grid settings
These parameters are set according to the
requirements of the selected country. Changing
these parameter settings can invalidate the type
approval of the unit. Change this setting only after
consultation with Delta customer service.
8.4.4.1 Overview
To change this setting, you need a special pass-
word provided by Delta customer service. You
can find the contact information on the back of
this document.
This menu area is used to define the behavior of the inverter in
the case of faults in the public grid.
The Grid Settings menu area has the following sub-areas:
Voltage protection The behavior of the inverter in the case of grid overvoltage or undervoltage.
Frequency protection The behavior of the inverter in the case of grid overfrequency or underfrequency.
Reconnection time The time waited by the inverter before reconnecting to the grid after a grid fault.
P ramp up The grid feed behavior of the inverter when reconnecting to the grid after a grid fault.
To Next Page
Loading...
Need help?
General
