Chapter 5 Parameters|VFD-B-P Series
Revision April 2009, SW V1.00 5-27
00 - 09 Control method
Factory Setting: 00
Settings 00 V/f control
01 V/f + PG Control
02 Vector Control
03 Vector + PG Control
This parameter determines the control method of the AC motor drive.
PG is encoder (Pulse Generator) feedback for which an option PG card is required.
Setting 00 and 01 are for V/f control mode. Setting 02 and 03 are for vector control mode.
When the control model is changed, the settings of Pr.02-03(PWM Carrier Frequency
Selections), Pr.06-01(Over-Current Stall Prevention during Accel), Pr.06-02(Over-Current Stall
Prevention during Operation), Pr.06-04(Over-Torque Detection Level) and Pr.08-07(Current
Limit for Speed Search) will be reset to the factory setting of the setting model.
00 - 10 Reserved
To Next Page
Loading...
