F800 Technical Description
PR-2013-0105-GB • Subject to modifications • R2-04/2016 11
If connected to the pool water condenser, about 65% of the thermal output is returned
to the pool water and about 35% to the hall air.
2.5 Air ventilation operation, no dehumidification requirement
As long as no dehumidification requirement is needed with the humidity switch in the
remote control, the F800 operates at low fan speed in ventilating/air circulation mode
in order to largely avoid wet corners and clouding of the windows.
2.6 Dehumidification operation
The dehumidification is switched on with the humidity switch in the remote control
whenever the inside air humidity rises above the preset setpoint. The high fan speed
and the compressor are then automatically taken into operation.
After the inside air humidity drops by about 5% rel. hum. below the preset setpoint, the
compressor is switched off (observe minimum standing and running period) and the
fan switched back to the low fan speed.
To Next Page
Loading...