What to do if my DencoHappel F800 unit switches off?
If your DencoHappel Dehumidifier unit switches off, there could be several reasons: * The main fuse might be defective: Replace the fuse. * The FI circuit breaker might have triggered: Have an electrician or factory customer service determine the cause. * The control fuse on the circuit board might be defective: Replace the appropriate fuse.
Why is the malfunction indicator on my DencoHappel Dehumidifier humidity switch red?
The red malfunction indication on your DencoHappel Dehumidifier's humidity switch could be due to: * Room air conditions outside operating limits: Ensure the temperature is between 22 °C and 36 °C, and humidity is between 40% and 60% relative humidity. * A dirty filter: Clean or replace the filters. * Insufficient refrigerant: Inform customer service.
What to do if my DencoHappel F800 Dehumidifier unit cannot be switched on?
If your DencoHappel Dehumidifier unit won't switch on, consider these potential causes: * No electricity: Ensure there is available electrical current. * Incorrectly laid cable: Check the wiring and lay the cables correctly. * Disconnected cable: Connect the interrupted cable.
What to do if motor circuit breaker Pool water pump of DencoHappel F800 Dehumidifier is triggered?
If the motor circuit breaker for the pool water pump in your DencoHappel Dehumidifier is triggered: * Reset the circuit breaker. If it triggers multiple times, inform customer service. * Ensure sufficient air supply to provide sufficient motor cooling. * Check whether all shut-off valves are opened and inspect water supply and drain pipes for blockage, because the pump may be running dry. * Reduce pipe cross-section to 1/2", because connecting lines may be dimensioned too large.
How to fix condensate drain problem in DencoHappel Dehumidifier?
If condensate isn't draining from your DencoHappel Dehumidifier, check the following: * The trap may not be correctly dimensioned: Install a trap with the required dimensions and provide an appropriate slope. * The trap or pan may be clogged: Clean the trap and pan.
Manual availability and scope of information covered for safe unit operation.
Explains manual symbols and identifies various safety instructions and warnings.
Guidelines for safe work and definition of correct application of the F800 unit.
Covers modifications, spare parts, disposal, and personnel qualifications for unit safety.
Provides an overview of the F800 unit and details its different types and designations.
Details optional accessories like remote controls, switch boxes, pumps, and thermostats.
Explains the functional principle, air ventilation, and dehumidification operations.
Presents detailed technical data, operating limits, and unit dimensions.
Instructions for receiving, checking, and reporting shipping damage for unit delivery.
Details safe transport procedures and permissible storage conditions for the unit.
Guidance on unit placement, clearances, and ensuring good air circulation for optimal performance.
Details on connecting two units and integrating outside air for enhanced room climate control.
Instructions for fitting specific adapters for extract-air and air intake connections.
Details on connecting water pipes, condensate drainage, and installing traps.
Crucial safety information and general requirements for electrical installation.
Detailed wiring diagram and connection points for a single F800 unit.
Instructions for mounting the humidity remote control at an optimal height and location.
Checks and requirements before initial commissioning and re-commissioning of the unit.
Procedure for setting room temperature, humidity, and switching on the unit.
Tips for economical operation and explanation of unit controls and indicators.
Recommendations for maintenance agreements and specific notes on pool water pump.
Instructions for cleaning the unit enclosure and checking/cleaning the air filter.
Lists common errors, possible reasons, solutions, and authority for troubleshooting.
Step-by-step guide for safely dismantling the unit, including electrical and hydraulic isolation.
Instructions for the environmentally-friendly disposal of the unit and its components by authorized contractors.
Details manufacturer information and identifies the F800 dehumidifier models.
Declaration of machinery compliance with EU directives and applied harmonized standards.
General| Brand | DencoHappel |
|---|---|
| Model | F800 |
| Category | Dehumidifier |
| Language | English |
To Next Page