F800 Shipping and Storage
PR-2013-0105-GB • Subject to modifications • R2-04/2016 15
At the installation site: • Remove outer packaging.
• Lift the unit only on the pallet. Do not lift the unit by the
rounded lateral casing. (Fig. 3-1)
• When using lifting and transport vehicles, employ only tech-
nical aids with sufficient loading capacity > 135 kg.
For proper transportation of the unit, remove the trim panels and
grille of the unit (see “Erect, assemble and connect” on page
16).
• Only lift the unit on the base frame.
Lift the unit with at least 3 persons. The weight is consider-
ably greater on the side with the switch box (refrigeration
system with compressor)!
3.3 Storage
Permissible storage conditions for non-installed units
Air temperature -10 °C to 50 °C
Air humidity 50 to 85 % r.h., no condensation
DAMAGE TO THE UNIT!
– Never lift the unit completely off the pallet. Only grip the unit by the base frame,
not by the lateral casing or the grille. There is risk of damage.
NOTICE!
– F800 may only be stored in weather-protected rooms
– Observe the permissible storage conditions.
– Remove the original packaging only just before installation.
– If the unit is stored for a period of time before installation or commissioning, pro-
tect it from damage through elements, build-up of dust and dirt!
– Prior to commissioning, take appropriate measures to protect units without pack-
aging against build-up of dust and dirt. Ensure conditions when condensate can
not form below packaging supplied by others (consider relevant clearance
between the packaging and casing).
– The unit may not be stored lying on its side.
To Next Page
Loading...