18
Tuning in radio stations
nListening to preset stations
1
Press SHIFT to select the memory
block (A to G).
[
TUNING /
]
[
CH+/-
]
Tuning
Preset
[
BAND
]
[
MEMORY
]
Band
Memory
[
MODE
] Mode
Preset Channel
A8 FM 90.1MHz
A7 FM 90.1MHz
A6 FM 90.1MHz
A5 FM 90.1MHz
A4 FM 108.0MHz
A3 FM 98.1MHz
A2 FM 89.1MHz
A1 FM 87.5MHz
TUNER
[
SEARCH
] RDS
2
Press CH + or CH – to select the desired preset channel.
You can also operate via the main unit. In this case, perform the
following operations.
Press TUNER PRESET CH + or TUNER PRESET CH – to select a preset
radio station.
RDS (Radio Data System)
Note that the RDS function only works when receiving RDS compatible
stations.
RDS (works only on the FM band) is a broadcasting service which
allows a station to send additional information along with the regular
radio program signal.
NOTE
The operations described as follows using
SEARCH will not function in areas in which
there are no RDS broadcasts.
nRDS search
Use this function to automatically tune to FM stations that provide
the RDS service.
1
Press TUNER to switch the input
source to “TUNER”.
2
Press SEARCH to select “RDS”.
[
TUNING /
]
[
CH+/-
]
Tuning
Preset
[
BAND
]
[
MEMORY
]
Band
Memory [
SEARCH
] RDS
[
MODE
] Mode
RDS
RDS
PTY
TP
RT
RDS Station
Program category
Traffic info.
Radio text
FM 87.50MHz
[
SEARCH
]Search Mode [
CH+/-
]Tuning
TUNER
3
Press CH + or CH –.
The search for RDS stations begins automatically.
•If no RDS stations are found with the above operation, all the
reception bands are searched.
•When a broadcast station is found, that station’s name appears on
the display.
•If no RDS station is found when all the frequencies have been
searched, “NO RDS” is displayed.
To Next Page
Loading...
