Denon AVR-1312 - Multi Channel Stereo Playback; Virtual Playback; Stereo Playback; Direct Playback

23
Multi channel stereo playback
This mode is for enjoying stereo sound from all speakers.
1
Playing the source (vpage 12
– 17).
2
Press SURROUND 0 or
SURROUND 1 to select “MULTI
CH STEREO”.
Multi channel stereo playback begins.
NOTE
When the input signal is Dolby TrueHD, Dolby Digital Plus, DTS-HD or
DTS Express, you cannot select multi channel stereo mode.
Virtual playback
This mode is for enjoying surround effects using only the front
speakers or headphones.
1
Playing the source (vpage 12
– 17).
2
Press SURROUND 0 or
SURROUND 1 to select
“VIRTUAL”.
Virtual playback begins.
NOTE
When the input signal is Dolby TrueHD, Dolby Digital Plus, DTS-HD or
DTS Express, you cannot select virtual mode.
GViews on the displayH
q w
q Shows a decoder to be used.
•A DOLBY DIGITAL decoder is displayed as “DOLBY D”.
•A DOLBY DIGITAL Plus decoder is displayed as “DOLBY DIGITAL
+”.
w Shows a decoder that creates sound output from the surround
back speakers.
For an input signal that can be reproduced in each surround mode, see
“Surround modes and surround parameters” (vpage51).
Standard playback
Stereo playback
This is the mode for playing in stereo. The tone can be adjusted.
•Sound is output from the front left and right speakers and subwoofer.
•If multichannel signals are input, they are mixed down to 2-channel
audio and are played.
1
Playing the source (vpage 12
– 17).
2
Press SURROUND 0 or
SURROUND 1 to select
“STEREO”.
Stereo playback begins.
Direct playback
Sound recorded in source is played as is.
•Surround back signals are not created.
•In this mode, the following items cannot be adjusted.
•Tone (vpage40) •RESTORER (vpage41)
1
Playing the source (vpage 12
– 17).
2
Press SURROUND 0 or
SURROUND 1 to select
“DIRECT”.
Direct playback begins.
Basic version
Advanced version
Information
Basic version