121 listening over headphones
1
Plug the headphones’ plug into the
jack.
3% Connect the headphones to the
PHONES jack.
The pre-out output (including the
speaker output) is automatically
turned off when headphones are
connected.
PHONES
+
1
[31 Turning the sound off temporarily (muting)
NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
Use this to turn off the audio output
temporarily.
Press the MUTING button.
24 Cancelling MUTING mode.
l Press the MUTING button again.
l Muting will also be cancelled
when MASTER VOL is adjusted
up or down.
MUTING
%
[41 Combining the currently playing sound with the desired image
Simulcast playback
Use this switch to monitor a
VIDEO SELECT
“ml SELECT
video source other than the
audio source.
Press the VIDEO SELECT
%%
button repeatedly until the
(Remote control mtj
desired source appears on
(Mm unit)
the display.
% Cancelling simulcast playback.
l Select “SOURCE” using the video select button.
l Switch the program source to the component
connected to the video input jacks.
t51 Checking the currently playing program source, etc.
1
Front panel display
l Descriptions of the unit’s
operations are
also
STANS
ST..NS
displayed on the front
panel display. In addition,
the display can be
switched to check the
%
unit’s operating status
(Mm unit)
memote control unit1
while playing a source by
pressing the STATUS
button.
2
Using the dimmer function
l Use this to change the
brightness of the display.
The display brightness
changes in four steps
(bright, medium, dim and
off) by pressing the main
unit’s DIMMER button
repeatedly.
iRemote control mtl
i i
BRIGHT - MEDIUM - DIM
t0w-J
36
To Next Page
Loading...
