0
8 CONNECTIONS
l Do not plug in the AC cord until all connections have been
completed.
l Be sure to connect the left and rrght channels properly (left with
left, right with right).
l Insert the plugs securely Incomplete connections will result In the
generatron of noise.
l Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
l Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
*Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
l When making connections, also refer to the operattng instructions of the other components.
The power to these outlets is turned on and off when the power is switched between on and standby from the remote control unit or power
switch.
OUTPUT
R L
CD player
1 Connecting a turntable )
Connect the turntable’s output cord to the AVR-18031883’s PHONO
jacks, the L (left) plug to the L jack, the R IrIght) plug to the rIQht jack
NOTES:
l
This un,t cannot be used with MC cartridges directly Use a
separate head ampllfler or step-up transformer
l
If humming or other nase IS generated when the ground wre IS
Turntable
(MM cartrldgel
Ground
WlE
1 Connecting the AC OUTLETS 1
AC OUTLETS
l
SWITCHED
itotal capacity - 120 W I1 A.))
The power to these outlets IS turned on and off I” conlunctlon with the
POWER operation switch on the man uwt. and when the &.ver IS swtched
between on and standby from the remote control ““It.
No power is supplied from these outlets when this unit’s power is at standby.
Never connect equipment whose total capacfty IS above 120 W (I A.).
NOTE:
Only use the AC OUTLETS for audio equipment Never use them for halr
driers, Ns or other electrical appltances
I Subwoofer jack
Connect the lntemal ampllfler’s subwoofer to the
subwoofer terminal. (Refer to page 17 1
MD recorder, CD recorder or other component
equipped with dlQltal InputJoutput lack
CD player or other
component equipped
with dIgItal output jacks
Connecting the DIGITAL jacks
Jse these for connections to audio ivIdeo) equipment with dIgItal o”tp”t Refer to page
7
AClZOV,60Hz
Route the connect,o” cords, etc , I” such a way
that they do not obstruct the ventllaton holes.
If humming nase IS generated by a
tape deck, etc., move the tape deck
for lnstluctlons on Setting this termlnai
l
Use 75
CUohms cable p,” cords for coaxial connections
l
Use optIcal cables for optical connections. removing the cap before connect,ng
24
1 Connecting a tape deck 1
Connections for recording:
Connect the tape deck’s recording Input jacks (LINE IN or REC) to this unit’s tape
recording iCDR/TAPE OUT) jacks using pin plug cords
Connections for playback:
Connect the tape deck’s playback output lacks (LINE OUT or PB) to this unit’s tape
playback (CDRFAPE INI jacks “Sl”Q PI” plug cords
9
To Next Page
Loading...
