2
ENGLISH
Getting Started
Connections Playback Remote Control Information Troubleshooting
SpecificationsMulti-Zone
Making the Optimum Settings for the Connected Speakers Automatically (Audyssey Auto Setup)
• If the result differs from the actual connection status or an error
message appears, use ui to on-screen display “Retry” and then
press
to repeat the measurement.
• If the result still differs from the actual connection status after re-
measurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn the AVR-1910 off, check
the speaker connections and repeat the measurement process from
the beginning.
• For instance, If the location or direction of a speaker is altered, the
Audyssey Auto Setup should be performed again to ensure the
correct EQ solution for the new room configuration.
NOTE
Do not change the speaker connections or subwoofer volume,
or speaker locations after making measurements. If changes are
necessary, make the changes and use the Audyssey Auto Setup once
again for an updated EQ solution.
8
Press .
This returns you to analysis results items, so repeat
step 7.
9
Press i to select “Next”, then
press .
10
Press ui to select
“Store”, then press
.
“Storing Please wait...” is
displayed on the on-screen
display while the results
are being stored.
When storing is complete,
“Storing complete. Auto
Setup is now finished.” is
displayed on the on-screen
display.
b If you do not want to save
the measurement results,
use ui to select “Cancel”,
then select “Yes” using
o p. All the measured
Audyssey Auto Setup data
will be erased.
NOTE
Do not turn the power off while the settings are being stored.
11
Disconnect the setup microphone from the AVR-
1910.
To Next Page
Loading...
