Denon AVR-3803

23
ENGLISH
3
Use the • and ª cursor buttons to display the
mode for which you want to make the punch
through setting, then press the ENTER button.
•“SEL” appears on the remote control unit’s
display.
TV ALL
AMP
CABLE
DBS
It is also possible to select the mode directly
using the mode buttons.
The display switches as shown below each
time the • and ª cursor buttons are
pressed.
4
Use the • and ª cursor buttons to display the
mode you want to punch through, then press
the ENTER button.
•“OK” is displayed and the punch through is
set.
CD CDR
MD
TAPE
DVD
VDP
VCR2 VCR1
It is also possible to select the mode directly
using the mode buttons.
The display switches as shown below each
time the • and ª cursor buttons are
pressed.
Setting the back light’s lighting time
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“BKLT” on the remote control unit, then press
the ENTER button.
•“05SEC” appears on the remote control unit’s
display.
DVD
2, 3
11
2, 3
3
Use the • and ª cursor buttons to adjust the
lighting time (3 sec ~ 30 sec), then press the
ENTER button.
•“OK” is displayed and that lighting time is set.
Resetting
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“RST” on the remote control unit, then press
the ENTER button.
•“PRE” is displayed.
(1) Resetting the preset memory
DVD
2, 3, 4
11
2, 3, 5
3
Use the • and ª cursor buttons to display
“PRE” on the remote control unit, then press
the ENTER button.
• After “SEL” is displayed on the remote
control unit’s display, the registered preset
memory is displayed on the remote control
unit’s display.
4
Use the • and ª cursor buttons
to select the code to be reset.
5
When the mode you want to reset is shown on
the remote control unit’s display, press the
ENTER button to reset the preset memory.
• The LCD’s back light flashes during the
resetting operation, and when the operation is
completed, “OK” is displayed and the set
returns to the normal operating mode.