Denon AVR-3803

24
ENGLISH
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“RST” on the remote control unit’s display, then
press the ENTER button.
•“PRE” is displayed.
(2) Resetting “learned” buttons
DVD
2, 3, 4
11
2, 3, 4
3
Use the • and ª cursor buttons to display
“LRN” on the remote control unit’s display, then
press the ENTER button.
•“SEL” is displayed.
4
Use the • and ª cursor buttons to select the
mode of the button to be reset, then press the
ENTER button.
• The LCD’s back light flashes during the
resetting operation, and when the operation is
completed, “OK” is displayed and the set
returns to the normal operating mode.
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“RST” on the remote control unit, then press
the ENTER button.
•“PRE” appears on the remote control unit’s
display.
(3) Resetting the system call buttons
DVD
2, 3, 4
11
2, 3, 5
3
Use the • and ª cursor buttons to display
“CALL” on the remote control unit’s, then press
the ENTER button.
•“SEL” appears on the remote control unit’s
display.
4
Press the • and ª cursor buttons to select the
system call setting to be reset.
The remote control unit’s display switches
as shown below each time the • and ª
cursor buttons are pressed.
CALL 1
CALL 2
5
To reset CALL 1 or CALL 2, select “CALL 1” or
“CALL 2”, then press the ENTER button.
• The LCD’s back light flashes during the
resetting operation, and when the operation
is completed, “OK” is displayed and the set
returns to the normal operating mode.