Denon AVR-3803

25
ENGLISH
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“RST” on the remote control unit, then press
the ENTER button.
•“PRE” is displayed.
(4) Resetting the punch through setting
DVD
2, 3, 4
11
2, 3, 4
3
Use the • and ª cursor buttons to display
“PUNCH” on the remote control unit’s, then
press the ENTER button.
•“SEL” appears on the remote control unit’s
display.
4
Use the • and ª cursor buttons to display the
mode whose punch through setting you want to
cancel, then press the ENTER button.
• The LCD’s back light flashes during the
resetting operation, and when the operation is
completed, “OK” is displayed and the set
returns to the normal operating mode.
TV ALL
AMP
CABLE
DBS
It is also possible to select the mode directly
using the mode buttons.
The display switches as shown below each
time the • and ª cursor buttons are
pressed.
1
Press the power ON/SOURCE button and the
OFF button at the same time.
•“PRE” appears on the remote control unit’s
display.
2
Use the • and ª cursor buttons to display
“RST” on the remote control unit, then press
the ENTER button.
•“PRE” is displayed.
(5) All reset function
DVD
2, 3
11
2, 3
3
Use the • and ª cursor buttons to display
“ALL” on the remote control unit, then press
the ENTER button.
• The LCD’s back light flashes during the
resetting operation, and when the operation is
completed, “OK” is displayed and the set
returns to the normal operating mode.
• This function is for resetting all the settings to the
factory defaults.