29
ENGLISH
1
Simulcast playback
Use this switch to monitor a video source other
than the audio source.
Press the VIDEO SELECT button, turn the
FUNCTION knob until the desired source
appears on the display.
[5]
Checking the currently playing program source, etc.
Using the dimmer function
• Use this to change the brightness of
the display.
The display brightness changes in
four steps (bright, medium, dim and
off) by pressing the main unit’s
DIMMER button repeatedly.
1
On screen display
• Each time an operation is
performed, a description of
that operation appears on
the display connected to the
unit’s VIDEO MONITOR OUT
jack.
Also, the unit’s operating status can be
checked during playback by pressing the
remote control unit’s ON SCREEN/DISPLAY
button.
Such information as the position of the input
selector and the surround parameter settings
is output in sequence.
Front panel display
• Descriptions of the unit’s
operations are also displayed
on the front panel display.
In addition, the display can
be switched to check the
unit’s operating status while
playing a source by pressing
the STATUS button.
(Remote control unit)
(Main unit)
(Main unit)
[4]
Combining the currently playing sound with the desired image
Cancelling simulcast playback.
• Select “SOURCE” using the VIDEO
SELECT button and the FUNCTION knob.
• Switch the program source to the
component connected to the video input.
(Main unit)
IN=V SOURCE
Display
[6]
Switching the surround speakers
1
The surround speakers switch
as shown below each time the
SPEAKER button is pressed.
(Remote control unit)
SURROUND A SURROUND B
SURROUND A+B
This operation is possible when the setting
for using both surround speakers A and B
is made at “Speaker Configuration” in the
System Setup Menu.
[1] Playing one source while recording another (REC OUT mode)
Multi-source recording/playback
1
Press the ZONE2/REC button.
(Main unit)
Display
NOTES:
• Recording sources other than digital inputs
selected in the REC OUT mode are also output to
the Zone 2 preout jacks.
• Digital signals are not output from the REC
SOURCE or audio output jacks.
2
With “RECOUT SOURCE”
displayed, turn the FUNCTION
knob to select the source you
wish to record.
• The “REC” indicator and the
indicator of the selected
source light.
(Main unit)
3
Set the recording mode.
• For operating instructions, refer to the manual
of the component on which you want to
record.
4
To cancel, turn the function
knob and select “SOURCE”.
• When “SOURCE” is selected,
the “REC” indicator turns off.
VCR -1 -2 / TAPE -1 -2
PHONO CD TUNER DVD / VDP TV / DBS
2
REC
RECOUT SOURCE
To Next Page
Loading...
Need help?
General
