Denon AVR-3803

30
ENGLISH
[2] Outputting a program source to an amplifier, etc., in a different room (ZONE2 mode)
2
Press the ZONE2/REC button.
(Main unit)
Display
NOTES:
• The signals of the source selected in the ZONE2
mode are also output from the VCR-1, VCR-2 and
CDR/TAPE recording output jacks.
• Digital signals are not output from the ZONE2
audio output jacks.
3
With “ZONE2 SOURCE”
displayed, turn the FUNCTION
knob and select the source you
wish to output.
• The “MULTI” indicator and
the indicator of the selected
source light.
FUNCTION
(Main unit)
4
Start playing the source to be output.
• For operating instructions, refer to the
manuals of the respective components.
VCR -1 -2 / TAPE -1 -2
PHONO CD TUNER DVD / VDP TV / DBS
3
MULTI
ZONE2 SOURCE
33,5
2
1
5
To cancel, turn the function
knob and select “SOURCE”.
• When “SOURCE” is selected,
the “MULTI” indicator turns
off.
FUNCTION
(Main unit)
1
Press the ZONE2 button.
(Main unit)
Light
4
The output level of the ZONE
2 OUT terminals can be
controlled using the
VOLUME + and - buttons on
the remote control unit.
The output level of ZONE 2 OUT can be
controlled only if ZONE2 vol. level is set
“Variable” at Zone2 Control in System Setup
Menu. (See page 15)
(Remote Control unit)
3
Press the input source button.
• The ZONE2 source switches directly.
[3] Remote control unit operations during multi-source playback (selecting the input source)
This operation is possible when ZONE2 mode is selected.
This operation is not possible in the REC OUT mode.
1
Select “ZONE2” using the
AMP button.
(Remote Control unit)
2
Press the ZONE2 “ON”
button.
To cancel the ZONE2
mode.
Press the ZONE2
“OFF” button.
3
2
1
4
5
(Remote Control unit)
DEFAULT SETTING (ZONE2 VOLUME
LEVEL) : - - - dB (MINIMUM)
5
When the ZONE2 SOURCE
function is set to TUNER,
the preset channel can be
selected using the
CHANNEL + and - buttons
on the remote control unit.
(Remote Control unit)
The main zone output
can be turned on and
off with the “MAIN
ON/OFF” button.