25
1
At the System Setup Menu, select “Multi Zone Control”.
2
Press jog stick “ENTER” to switch to the “Multi Zone Control” screen.
[2] Setting the multi-zone level
3
Select “Multi Zone Vol. Level” then press jog stick “ENTER”.
4
Select “Surround Back” to use as the surround back
channel, “Multi” to use as multi-zone, then press jog
stick “ENTER”.
When “Surround Back” is selected When “Multi” is selected
4
Select the desired setting, then press jog stick “ENTER”.
Variable:
The level can be adjusted freely using the buttons on the remote control unit (M. ZONE 1 4/5,
VOLUME UP and VOLUME DOWN).
-40 dB, 0 dB:
The output level is fixed at the set level and the volume can no longer be adjusted.
NOTE: The multi zone volume level is not displayed when “Multi” is selected at the “Power
Amp Assignment” setting.
To Next Page
Loading...
