Denon AVR-X2400H

1. Version Display Mode
1.1. Actions
Version information is displayed when the device is started in this mode.
1.2. Starting up
While holding down buttons "
DIMMER
" and "
STATUS
" simultaneously, press the power button to turn
on the power.
then press the "
STATUS
" button to display the information in section 1.3 on the display.
b
The version list is also displayed on GUI while the version is displayed on the display.
1.3. Display Order
Error information(See "1.4. Error display") →
q
Model destination information →
w
Serial Number
→
e
Firmware Package →
r
Main μ -com →
t
Main 1st Boot Loader →
y
DSP
→
u
Audio PLD →
i
GUI SFLASH →
o
HEOS Version →
Q0
HEOS Build →
Q1
HEOS Module
→
Q2
HEOS Conguration →
Q3
HEOS Locale →
Q4
Ether Mac Address →
Q5
WiFi Mac Address
→
Q6
BT Mac Address →
Q7
Audyssey App Interface Version
q
Model destination information :
AVR-S930H E3 *
AVR-X2400H \\\ *
\
: Region (E3, E2, E1C, JP)
w
Serial Number :
SN**************
e
Firmware Package :
Package :****
r
Main µ-com :
M:*************
t
Main 1st Boot Loader :
Main FBL :**.**
y
DSP ROM :
DSP :**.**
u
Audio PLD :
Audio PLD:**.**
i
GUI SFLASH :
GUI :@@$\****
@
: Model code,
$
: Brand code (DENON=1),
\
: Region code (E3=1, E2=2, E1C=5, JP=4,
ALL=0),
*
: version
o
HEOS Version :
HEOS Version
"Press "
STATUS
" button.
*.***.***
Q0
HEOS Build :
HEOS Build
"Press "
STATUS
" button.
******
Q1
HEOS Module :
HEOS Module
"Press "
STATUS
" button.
***
Q2
HEOS Cong :
HEOS Config
"Press "
STATUS
" button.
Production
Q3
HEOS Locale :
HEOS Locale
"Press "
STATUS
" button.
*****
Q4
Ether MAC Address :
*Ether MAC
"Press "
STATUS
" button.
******-******
Q5
Wi-Fi MAC Address :
*Wi-Fi MAC
"Press "
STATUS
" button.
******-******
Q6
Bluetooth MAC Address :
*BT MAC Address
"Press "
STATUS
" button.
******-******
Q7
Audyssey App Interface Ver :
Audy IFVer:**.**
124
Caution in
servicing
Electrical Mechanical Repair Information Updating