Denon PRIME 4 - PRIME 2;PRIME GO FX Parameters; Flanger, LFO Filter, Phaser, Crush, Roll, Rev. Roll, Scratch, Reverb

59
Phaser Parameter Value Range
This effect adds a copy of the original signal with its phase
shifted slightly to create a subtle, modulatory effect.
Beats 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 3/4, 1,
2, 4, 8, 16, 32
Wet/Dry 0–100
Crush Parameter Value Range
This effect applies bit reduction to the original signal for a
lo-fi, down-sampled effect.
A
VG 0–100
Wet/Dry 0–100
Roll Parameter Value Range
This effect samples the current audio signal and repeats it at
a regular rate based on the current time division.
Beats 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 3/4, 1,
2, 4, 8, 16, 32
Wet/Dry 0–100
Rev. Roll Parameter
V
alue Range
This effect (reverse roll) samples the current audio signal
and repeats it backward at a regular rate based on the
current time division.
Beats 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 3/4, 1,
2, 4, 8, 16, 32
Wet/Dry 0–100
Scratch Parameter Value Range
This effect alternates between normal and reverse playback
of each beat, creating a vinyl-scratching effect.
Beats 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 3/4, 1,
2, 4, 8, 16, 32
Wet/Dry 0–100
Reverb Parameter Value Range
This effect adds reverberation to the original signal. Decay 0–100
Wet/Dry 0–100