45
Settings
PRIME 4
Device
• Deck 3/4: This determines whether this PRIME 4 will use both deck layers (On) or just one (Off).
• Wi-Fi: This determines whether Wi-Fi connectivity is enabled (On) or disabled (Off). Tap the gear icon to open
the Wi-Fi settings. See Control Center > Wi-Fi for more information about the Wi-Fi menu.
• Time/Date: This displays the current local time and date. Tap Sync Time when connected to the internet to
automatically sync the time.
• Time Zone: Displays the current time zone, formatted as Continent / City.
• Set time zone manually: Enable this setting and then tap the gear icon to manually set your local time zone.
• Platter Touch Sensitivity: Tap Calibrate to recalibrate the touch sensitivity of the platters to default. Make sure
not to touch the platters during calibration.
• Track Preview: When active, Track Preview will reveal a play button for each song in the library, allowing the
songs to be auditioned in the cue without loading a song to the deck. Select On or Off.
• Screen Brightness: This setting determines the brightness of the main display: Low, Mid, High, or Max.
Mixer
• Playlist Deck Crossfade Time: Use this slider to adjust the amount of crossfade between tracks when using the
playlist deck.
• Master Limiter: This setting determines the maximum output level of the master mix. Select Off to disable the
limiter, or set the maximum output level from 18 to 0 dB.
• EQ Type:
This setting determines the type of equalization for the Channel EQ knobs. Select Isolate for EQ
bands with infinite cut for full band "kills," or select Norm for EQ bands with limited cut.
• ISO EQ High Xover: When EQ Type is set to Isolate, this setting determines the crossover frequency between
the Mid and High EQ bands, from 1000 to 8000 Hz.
• ISO EQ Low Xover: When EQ Type is set to Isolate, this setting determines the crossover frequency between
the Low and Mid EQ bands, from 100 to 800 Hz.
• Filter Resonance: This setting determines the amount of resonance of the filter, from 0 to 15.
• Filter Extreme Type: This setting determines the effect of the Sweep Filters at the extreme low and high ends.
Select Kill for the filter extremes to end in silence, or select Bleed to allow the extreme end of the filter to play.
• Noise Sweep Volume: This setting determines the level of the Noise Sweep effect in the mix when active, from
-20 to 15 dB.
• Headphone Gain: This setting determines the amount of gain for the Headphones outputs, from -10 to 10 dB.
• Cue Solo Mode: This setting determines how many channels can be sent to the cue mix. Set to On to have only
one channel at a time in the cue mix, or set to Off to cue multiple channels at a time.
• Split Cue Output: This setting determines the stereo positioning of the pre-fader cueing mix and main mix when
Split Cue is enabled. When set to Normal, the pre-fader cue mix will be stereo left and the main mix will be
stereo right. When set to Invert, the pre-fader cue mix will be stereo right and the main mix will be stereo left.
To Next Page
Loading...
