18
(9) If the completion screen appears, click Finish.
(10) To make sure that the USB-COM device driver has been successfully installed, open the Windows’ Device Manager.
If DENSO WAVE USB-COM Port is added to the sub-tree of Ports (COM & LPT) as shown below, the scanner
is connected normally.
If the device is not added or it is marked with
or , remove this driver with the uninstaller, reboot your computer,
and perform the above connection process again.
Windows XP
(1) Switch the computer on to run Windows XP. Log on as an Administrator.
(2) Connect the scanner to the computer or the USB hub, and the "Found New Hardware" appears on the task tray.
To Next Page
Loading...
