Denso GT10B-SU - Chapter 8 Scanning Functions; Data Verification Mode; Verification Setup Procedure

28
Chapter 8 Scanning Functions
8.1 Data Verification Mode
The data verification mode verifies the bar code data read against the master data stored in the scanner and reports the
match status with data output.
The verification parameters can be set using the bar-coded parameter menu or configuration software (ScannerSetting).
After setting them, scan a master bar code, and the scanner becomes capable of data verification read.
8.1.1 Verification setup procedure
- Switch to the data verification mode.
- Set the verification parameters
(verification conditions and result
output ways).
Use the bar-coded parameter menu or the configuration software.
The indicator LED flashes in red, indicating that no master bar code is
registered in the scanner.
↓
Scan a master bar code to register.
Hold down the magic key to light the indicator LED in green. Keep the
magic key held down and press the trigger switch to scan a master ba
r
code.
↓
Scan bar codes.
Use the scanner to scan a target bar code. The scanner verifies the ba
r
code read against the master data registered and then outputs the result.
Note: If you change the verification parameters after registering a master bar code, the master bar code data stored
will be cleared.