56
Chapter 13 Bar-Coded Parameter Menu
13.1 Parameter Setting Procedure Using the Bar-Coded Parameter Menu
"Start setting"
Scan the "Start setting" bar code.
↓ Three beeps
Scan parameter setting
bar codes.
Scan desired parameter setting bar codes.
NOTE: When using the bar-coded parameter menu, scan bar codes within three minutes.
Otherwise, the scanner cancels newly settings and returns to the previous ones.
↓
"End setting"
Scan the "End setting" bar code.
Three beeps
Scanning the "All defaults" bar code in the bar-coded parameter menu makes all items in the menu revert to the factory
defaults.
TIP: "Interface" and "Beeper volume" bar codes in the bar-coded parameter menu
These items can be set even if the above procedure is omitted. No "Start setting" or "End setting" bar code is required to be
scanned.
To Next Page
Loading...
