- 66 -
9-2 Checking/first 50 hours
(1) Checking on nylon and rubber hose
Check on the nylon and rubber hose, whether they are hardened or deteriorate.
Contact distributor or our office to replace the nylon hose and rubber hose, if necessary.
9-3 Checking/every 100 hours
(1) Checking on nylon and rubber hose
Check on the nylon and rubber hose, whether they are hardened or deteriorate.
Contact distributor or our office to replace the nylon hose and rubber hose, if necessary.
9-4 Checking/first 125 hours
(1) Replacement of engine oil
Replace the engine oil at 125 hours only first time and every 250 or 500 hours
after second time.
① Remove the engine oil drain plug and discharge oil completely. It can be
discharged easily when the engine is warm.
② After engine oil is discharged, tighten the plug firmly.
③ Charge new engine oil from the oil filler until it reaches the notched line
of the "H"
on the dipstick.
④ After engine oil is supplied, run the engine for a few minutes. Check that
oil is supplied to the level between H and L .
(2) Replacement of engine oil filter cartridge
Replace the engine oil filter at 125 hours only first time and every 250 or 500 hours
after second time.
Cartridge type (cartridge type is unit of filter case and element)
① Remove the cartridge type element (cartridge)
using filter wrench.
② Clean the filter base. Coat the packing of new
cartridge with engine oil thin. Then, mount the
cartridge.
・When mounting, tighten the cartridge from
3/4 to 1 turn by using filter wrench after the
packing is fitted to the seal of the filter base.
To Next Page
Loading...
