SecurAccess Compact – User Guide 31
12. PROGRAMMING
12.1. Entering the local programming mode
1. Open the unit
2. Connect to the telephone line
3. Reach the small programming keypad
4. Press “*” key and, while keeping it depressed, press one of the off-hook memory buttons.
5. Release the off-hook memory button first and the “*” key after : 2 “beep” tones will confirm
entering the programming mode.
6. Enter the 4 digits code within 8 seconds :
Ö If a wrong code is entered or if it takes more than 8 seconds to enter the code, 1 “beep”
tone confirms a wrong code was entered: resume the operation at point 4.
Ö If the code is correct, 2 “beep” tones will be emitted confirming entering the programming
mode.
Keep depressed M1 (off-hook memory button) and * (small keypad inside)
Release M1
Release *
2 “beep” tones: entering the programming mode
Enter 0000 4 digits access code (0000: factory settings)
2 “beep” tones
Confirming entering the programming mode
Note:
All correct entries are confirmed by a double “beep” tone Wrong entries are confirmed by a low long
“beep” tone and the unit will hang up.
To Next Page
Loading...
