SecurAccess Compact – User Guide 35
If busy tone is detected, the unit will automatically dial the next number stored in the memory. In case
of no answer, time elapsed before dialling the following number stored can be adjusted as shown
below:
Setting to modify Code Setting choice
Factory settings are shown in grey
Conf
Elapsed time before next call 0 8 0 : 10 seconds
1 : 20 seconds
2 : 35 seconds (factory setting)
3 : 1 minute
4 : 5 minutes
*9
If no busy tone and no answer, the dialling sequence can be repeated up to 9 times, choice of the
number of times can be made as shown:
Setting to modify Code Setting choice
Factory settings are shown in grey
Conf.
Repeated dial 0 9 Enter 0 up to 9 (0 for no repeated dial),
note: factory setting = 0
*9
When the total numbers of calls has been completed, the SecurAccess Compact will stop dialling and
will hang up.
Example N°1:
A list of 5 numbers stored. Repeated dial selection is 9. In case of busy tone and (or) no answer, the
SecurAccess Compact will dial 10 times the list of 5 numbers (1 first trial plus 9 repeated trials).
Example N°2:
A list of 3 numbers stored. Repeated dial selection is 0. In case of busy tone and (or) no answer, the
SecurAccess Compact will dial the list of 3 numbers one time and will hang up.
12.8. Ringer
3 levels adjustment: off-low-high and 3 melodies selection. Adjust as shown:
Setting to modify Code Setting choice
Factory settings are shown in grey
Conf
Ringer level 0 3 Low : 0 - High : 1 *9
Ringer melody 0 4 0 : ringer off
1 : Melody N°1
2 : Melody N°2
3 : Melody N°3
*9
12.9. Automatic answering
An auto answer mode can be activated for calling a party standing close to the SecurAccess
Compact or to enter the remote programming mode. The SecurAccess Compact will automatically go
off-hook after a pre programmed number of rings:
- From 1 up to 9 rings when automatic off-hook selection is activated
- After 30 rings otherwise.
Setting to modify Code Setting choice
Factory settings are shown in grey
Conf.
Auto answer 0 5 Enter the number of rings before auto answer (0 up to 9)
Note: 0 = feature deactivated
3 = factory setting
*9
To Next Page
Loading...
