Depaepe Telecom SecurAccess Compact - Page 33

SecurAccess Compact – User Guide 33
5. Repeat the operation for other settings choices or terminate by hanging up or by
entering 99 for immediate hanging up.
Example N°1: In the local programming mode, storing number 18 in Memory key 1 (without chain
dialing)
Settings Code Setting choice Conf.
M1 storing for key 1 2 0 Number (22 digits max.) *9
Keep depressed M1 (front panel button) and * (small keypad inside)
Release M1
Release * button
2 “beep” tones: entering the programming mode
Enter 0000 4 digits access code (0000: factory settings)
2 “beep” tones
Confirming entering the programming mode
Enter 20 Setting code access
2 “beep” tones
Confirming the entry
Enter 18 Number to store (18 in this example)
Enter *9 Confirming stored setting
2 “beep” tones
Confirming the operation
Example N°2: : In the remote programming mode, change loudspeaker volume to “medium”
Settings Code Setting choice Conf.
Loudspeaker volume 06 Low: 0 – Medium : 1 – High : 2 *9
Calling the SecurAccess Compact using a Tone dialling telephone.
Dial 0XNNNNNNNN Calling the SecurAccess Compact
2 “beep” tones
The SecurAccess Compact answers and goes off-hook
Enter * Entering the programming mode
2 “beep” tones
Confirming the entry
Enter 0000 4 digits (Factory setting : 0000)
2 “beep” tones
Confirming the entry
Ente 06 Setting code access
2 “beep” tones
Confirming the entry
Enter 1 Setting choice (medium)
Enter *9 Confirming stored setting
2 “beep” tones
Confirming the operation